American-sanders American 8 Drum Sanders Manuel d'utilisateur télécharger pdf (Page 6)

Page 6 Clarke

American Sanders American 8 Floor Sander Operator's Manual

230V Electrical Connection Instructions

CAUTION: This machine will operate only on AC frequency and on electrical voltage shown on the motor nameplate.

Make sure you have the correct frequency and voltage before connecting the power cord to an outlet. The

machine has a plug as shown below.

This machine must be connected to an electrically ground circuit in order to protect the operator from electric shock. This machine has

an approved power cord with three conductors as well as a plug with three terminals. Connect the plug into a three holed receptacle.

For maximum protection against electric shock, use a circuit that is protected by a ground fault circuit interrupter.

DANGER: Electrocution could occur if the machine is exposed to water or rain. Keep the machine in a dry building.

DANGER: Electrocution could occur if machine is improperly connected to the electrical system. To prevent possible

electric shock, always use a 3 wire electrical system connected to an electrical ground. For maximum pro-

tection against electrical shock, use a circuit that is protected by a ground fault circuit interrupter. Consult

your electrical contractor.

DANGER: Electrocution could occur if the ground pin is tampered with in any way. Do not cut, remove, or break the

ground pin. Do not try to t a three-terminal plug into a receptacle or connector body other than a three

plug receptacle or connector body. If the outlet does not t the plug, consult your electrical contractor.

DANGER: Electrocution could occur if the machine is used with a damaged plug or power cord. If the cords or plugs

are worn or damaged in any way, have them replaced by an authorized service person or electrician.

Extension Cords

Use only an approved three-pronged extension cord with two main conductors and one earthing conductor. This machine’s power cord

has a wire size of 10 gauge. This machine is equipped with a 100’ power cord. When greater range is needed follow the table below

to determine cable guage of additional footage. Refer to the following chart for extension cord information.

Feet/Wire Guage (Stranded Copper)

Source Voltage 0-100’ 100-250’

208 6 Use Voltage

Booster

230 10 8

If motor appears to labor or takes a considerable longer time to come up to speed reduce sanding pressure.

1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Pas de commentaire

American-sanders American 8 Drum Sanders Manuel d'utilisateur Page 6