American-sanders American 8 Drum Sanders Manuel d'utilisateur télécharger pdf (Page 8)

Page 8 Clarke

American Sanders American 8 Floor Sander Operator's Manual

Machine Set-Up

To set-up your machine follow this procedure:

1. Familiarize yourself with the machine and read all danger,

warning and caution statements. Make sure all operators

of this machine have read this Owner’s Manual. If they

cannot read English, have the manual explained fully before

allowing anyone to operate the sander.

2. Locate the power supply. The receptacle should be

compatible with the plug. The receptacle must be grounded

and must be fused (30 amp) to avoid an electrical hazard.

3. Clip the dust bag to the elbow. Cross the strings on the dust

bag and draw tight over the are on the elbow. Wrap the

string around the elbow and secure.

4. Wind the power cord through the cable arm. Keep the

power cord out of path of equipment.

How To Install The Abrasive

WARNING: Disconnect power before

changing abrasive.

To install the abrasive, follow this procedure:

1. Prepare abrasive with template supplied.

2. Place backing of abrasive on the template. The template is

marked “This Side Up.” Make sure the marked side of the

template is facing up.

3. Cut the abrasive to the exact lenght of the template.

4. Align one edge of the abrasive with a notch in the template.

5. Fold the other end of the abrasive over the end of the

template and crease.

6. Repeat steps 4 and 5 for remaining notch.

7. Lift the drum cover.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Pas de commentaire

American-sanders American 8 Drum Sanders Manuel d'utilisateur Page 8